<--ASINB002FDEJ3Y-->

010330 Motorcycle Exhaust Pipe Wrap Only $42.43 @ Amazon Rated 5 of 5 Stars by 15 Buyers!

010330 Motorcycle Exhaust Pipe Wrap

I employed this on my Road King that I redid. I was going with an old school look and employed the black wrap kit on the headers of my exhaust. Take your time to soak the wrap and utilise neatly. After fully drying, spray various light coats with the included black silicon spray. I ordered an extra roll of wrap, nonetheless the kit was sufficient to do my dual exhaust. Mine has kept up well and looks great.

This is a in truth outstanding productions It only took when it comes to an hour to apply to both pipes. However it didn’t come with as much wrap as I was expecting. It only wrapped when it comes to half of every pipe (was looking to wrap when it comes to 3/4 each.) For the price you can not beat it though.

Also they can’t ship this item any other way accept for ground because of the aerosol can, And make certain to soak your wrap in water before you apply!

Good product, easy to use and apply. Two 15′ wraps were provided. I had just sufficient to wrap the header pipes (dual pipes), which is all that I intended to wrap. whether or not you plan on wrapping more, buy an extra wrap. Wet them prior to installation and wrap from the back of pipe to the cylinder. This makes is better for aerodynamics that will prevent the wrap from peeling back at high wind speeds. The metal zip ties are ok, but I’d commend using radiator hose clamps at every end. It looks cooler too. The pipes will smoke and stink beautiful bad when you primary start the bike. This is normal for the first small bit. They will as well smoke when they get wet at first. Totally normal and at last goes away. Overall, I like them. They look super cool as long as you’re going for the old school bobber/rat look. They give the bike a small more bottom end and a deeper rumble from the pipes (at least they do with my bike).

I plan on using these again with my other bikes. Good productions

I utilized this for my 2005 SV650S. I wrapped the front header, the y-collector and the high mount slip on pipe. After doing this I had a little bit of extra wrap and a bunch of ties left over.

Few steps to make it look outstanding and last.

*clean rust off pipes before applying

*I used the high temp black paint to the pipes before the wrap this is up to you

*soak the wrap with a hose outside and wrap it TIGHT

*put on 3-4 coats of the paint onto the wrap

*the wrap hardens a lot with the paint, and I suspect will last longer without fraying or discoloring like my old DEI wrap did without the paint or being used wet

Great kit I’d recommend it to anyone.

Went on great, very messy whether or not you soak it, but it makes the final product much better looking. The spray is great, cause after it runs for a while, the wrap fades out and you can just spray the wrap and its back to a nice black. I will definitely be wrapping all my bikes from now on.

Aside from the chinsy zip ties and the smoke this product is great. Do yourself a favor and get such a good deal of screw clamps to secure the wrap. The zip ties just didn’t get tight sufficient to make me feel confident hey were holding properly. The pipes will smoke for a couple days post wrap, while it cooks off impurities, not one thing to worry about.

Throw on such a swell deal of tunes, grab a beverage and get wrapping.

The two 15′ exhaust wrap rolls were just enough to wrap my wife’s Vance and Hines 2 into 2 Big Radius pipes (for a Sportster 48), and they look sweet! The wrap is actually gray/silver, your supposed to use the silicon spray to make it black but the wife prefers the gray/silver color so I didn’t use the spray. I only used eight locking ties so I have assorted extras now, and the exhaust wrap is very secure. Decent instructions (no pics). Since we wrapped the pipes with the existent heat shields in place, can’t comment on heat reduction, sorry.

This kit definitely added an aweinspiring custom look, we love it is

I obtained this product in swell condition and if applied according to the instructions and general sense will prove itself a great product!

its been on the motorcycle for in regards to 4 months now and its still holding up great, I have only re-sprayed it black once.

Great Product, Fast shipping, easy to work with marketers

I bought this wrap to change the look of my pipes as well as cut down on such a lot of of the heat radiating up to my leg. It works great on both counts. I love the black paint and how it adds a bit of a completed look to the wrap. Easy to install, too.

This product is great. Just make certain you do the research on how much you need for the length of pipes you have. I ran into the problem of not having enough and had to purchase more. Great starting point, but opportunities are you will need more wrap.